Levers must be fully down and locked. Indicators and Lights Check for correct operation of all indicators and lights. You will not be dissatisfied. Check the electrical charging system. Tighten the nuts to 40-50 ft.
If the level is low, add oil through the check plug hole until the oil flows from the hole. W-2059-0598 Figure 10-50-3 Raise the operator cab. This is a must for the Do-It-Yours. Using a damaged lift arm support or with missing parts can cause lift arms to drop causing injury or death. Put oil on the seal of the new filter element. Lowering The Operator Cab Figure 10-30-4 Always stop the engine before raising or lowering the cab. Inspect the hoses and fittings for leaks.
Failure to use jackstands can allow the machine to fall or move and cause injury or death. Use the correct procedure to lift or lower operator cab. Check for leaks and check the oil level. Case Drain Filters Replace the filters. Open the rear door of the loader. Tire Mounting Tires are to be repaired only by an authorized person using the proper procedures and safety equipment.
See Engaging The Lift Arm Support Device on Page 10-20-1. Drain the oil into container. Open the rear door of the loader. Untrained operators and failure to follow instructions can cause injury or death. Failure to use an approved lift arm support device can allow the lift arms or attachment to fall and cause injury or death.
Check rim and tire bead for damage. Untrained operators and failure to follow instructions can cause injury or death. Install the case drain filter and tighten the hoses. Keep heat, flames, sparks or lighted tobacco away from fuel and oil. Always use a good quality lithium based multi-purpose grease when you lubricate the loader.
Placing the key switch of the remote start tool in the run position disconnects the operator panel key switch from the start circuit. To check the reservoir, use the following procedure: Put the Bobcat loader on a level surface. Add oil as needed if it is not at the top mark on the dipstick. Start the engine an doperate the loader hydraulic controls. Changes to the cab can cause loss of operator protection from rollover and falling objects, and result in injury or death. Disconnect the spring from the lift arm support device retaining pin Item 1.
Clean the surface of the filter housing where the element seal contacts the housing. Tighten the air vent plug. The knob will come out to release the solenoid valve. Do not use your bare hand. Figure 10-60-2 Lift and block the loader. Steering King Pins Lubricate with multi-purpose lithium based grease. Extra insulated cab is available as an option Reduced noise level.
Toxic dust or gas can be produced. Explanation of loader Serial Number: 1. The switch is used when checking pressures and flow rate. Repair or replace as needed. Put clean oil on the rubber seal of the filter elements. Check for correct function after adjustments, repairs or service.
Keep the battery terminals clean and tight. A general inspection of the following items must be made after the loader has had service or repair: 1. See Raising The Operator Cab on Page 10-30-1. . When installing wheel nuts, tighten to 160 ft.
Run the engine until it is at operating temperature. Apply the lubricant until extra grease shows. Clean often to avoid this accumulation. Remove the plug and drain the fluid into a container. Stop, cool and clean engine of flammable materials before checking fluids. The five digit Production Sequence Number identifies the order which the loader is produced.