It includes permissive synchronising check functions for automatic and manual breaker closure operations. After the condition has been corrected, the Shutdown indicator can be reset by turning the Mode switch to the Off O position, and pressing the Reset button. Genset indications are provided on the control panel. . The display is also used to show Warning and Shutdown messages.
Alarm requiring controlled engine stop. The 3 X current is based on the genset rating, not the alternator rating. For details on any of the above services contact your distributor. Warning, signals an imminent or non-fatal engine fault. . Furthermore, equipment that does not form part of the genset installation may become electrically charged. So, if you only use one phase, it will logically take three times the expected level of current to get to tripping time.
© 2010 Cummins Power Generation, Inc. Apart from the protection systems, there is no common coupling between gensets. Engine temperature should rise rapidly and then stabilise after a few minutes. . The breaker close operation is operated through a permissive function with dead bus logic to prevent accidental out of phase paralleling of the genset to the system bus.
The alternator has its own internal cooling fan. We will be glad if yourevert again and again. The idle speed can be adjusted only when the genset is running in the Idle mode. To prevent this damage, always wear a grounding wrist strap when touching or handling either circuit boards or socket-mounted lCs, and also when disconnecting or connecting harness connectors. The seal area is on the inside of the open end of the filter. Wipe out the interior of the air cleaner housing and cover with a clean, damp cloth. Caution: Filters should be handled with care to prevent damage.
Check the engine speed and ensure that the engine is running near to nominal speed. Refer to the engine manual for recommended operating pressures and temperatures. I assume these levels are closer to the curve. Add coolant to the recovery tank to replace the normal loss of coolant. Figure 2-1 Typical Generator Set Rating Plate 07-2008 2-1 2. They must be filled with the correct type and quantity of oil before use.
. H-2 07-2008 J0960-0059 Issue 1 8. An optional key function may be provided to prevent unauthorised operation of the switch. Metal Base Fuel Tank Option 07-2008 G-1 8. Most engine problems give an early warning. . It heats and circulates the coolant within the engine, reducing start-up time and engine wear caused by cold starts.
Investigate anything that indicates possible mechanical problems. In Auto mode, shutdowns can be reset by removing the remote start input and then cycling the remote reset input. F-2 07-2008 J0960-0059 Issue 1 8. Check for oil, fuel, cooling and exhaust system leaks. Voltage sub-menu: This is the first sub-menu. The low Figures 5-8 through 5-11 show the locations of the oil and coolant temperature and oil pressure send- coolant level switch has its own ground wire.
Additional indications of genset output current can be accessed by selecting the Gen menu on the alphanumeric display. Select Save to save your changes. . . Caution: One operator should be in complete charge, or working under the direction of someone who is. It is therefore normal to give batteries a regular charge at their full rate to return all cells to full capacity.
If the fuel level is low, the upper portion of the tank tends to form condensation. Up to 2000 amp generator rating circuit breakers are installed in a set-mounted load box which is close coupled to the alternator output terminal box. Remember that, upon starting the engine, cables and switchgear will become energised, possibly for the first time. Ensure the area is well ventilated before disconnecting batteries. Figure 3-2 Typical Alarm Module Front Panel 07-2008 3-5 3.
. Repair or service as required. The illumination will shut off automatically after approximately eight minutes to save battery power. These bearing are sealed for life. Ensure that spreader bars are incorporated into the lifting gear to avoid damage to the generator set and its ancillaries. Start the engine in Idle mode using the Manual Run button on the switch panel to start the engine refer to Starting at the Control Panel in Section 5. .